DX Engineering DXE-TCB-UNFK, Руководство пользователя

Страница: 9 / 16

- 8 -
Figure 3
Position the UNUN so it faces forward as shown in
Figure 4 . Tighten the Upper and Lower
Studded Clamps and tighten the Nyloc Nuts holding the bracket to the Upper and Lower Studded
Clamps.
Feedline Connections
The
DXE-UN-43 UNUN is attached to the antenna feedline connections using the DXE-TCB-
UNFK UNUN Feed Point Connection Kit which contains two pre-drilled copper tinned braids.
Both braids are 1" wide by 9" in length. Connect one braid from the antenna feedpoint located on
the base section of the antenna to the terminal on the
DXE-UN-43 UNUN closest to the
Red "+"
on the label as shown in Figure 5 . Do not over tighten the wing nuts. Hand tighten them only, do
not use pliers or other tools to over tighten the wing nuts.
Connect the other 9" braid from the terminal on the
DXE-UN-43 UNUN closest to the
Black
"
▬"
on the label to the closest radial wire bolt on the optional DXE-RADP-3 Radial Plate as
shown in Figure 5 . Route both braided cables as shown. Ensure the "+" connection is not shorting
out to the "-" side.