- 3 -
next radial mounting hole and connect it there (double up on one radial mounting hole). Mount the
insulated coil mounting bracket to the "L" bracket on the coil assembly using the hex head bolt, two
flat washers, star washer and Nyloc nut as shown in
Figure 2
. When installing stainless steel
hardware, it is suggested that
UMI-81343, UMI-81464, DXE-NSBT8
or
DXE-NMBT8 - Never-
Seez
or
Anti-Seize
be used to prevent thread galling on stainless steel.
Figure 2
Install the coil assembly to the mounting shelf using the hex bolt, two flat washers, one external
tooth washer and Nyloc hex nut as shown in
Figure 3
.
Figure 3
The wire with ring terminals goes from the end of the coil to the MatchBoxx™ "ANT" connection
as shown in
Figure 4
.
Figure 4
The end of the 45 foot vertical antenna element is routed through previously mounted insulator to
the coil insulator. The wire then goes through the large hole on the coil insulated bracket to the end
of the coil (end where the "L" bracket is attached) and is held in place with one external tooth
washer and stainless steel hex nut as shown in
Figure 5.
