Dwyer Instruments ULS Series, Руководство пользователя

Страница: 17 / 30

Rev 5 MN890570 17 of 30
ULSX ‐ CAL ‐ WRITE TO UNIT Step Seven
After you have entered configurations and tank
values, click “ Write to Unit ” and send the
configuration to your Series ULS. Now use ULSX ‐ CAL’s
file management features to save your configuration
by clicking “ Save Config File ” and print your wiring
diagram by clicking “ Wiring Diagram .”
Write to Unit
Wiring diagram
Save Config File
Wiring Diagram ‐ Sample
Diagram will change based upon the configuration of the Series ULS,
use ULSX ‐ CAL to view appropriate wiring diagram.
Wiring Series ULS: Once Series ULS has been installed, follow the Wiring Diagram provided by the ULSX ‐ CAL
software. A typical wiring diagram is shown above. Dwyer Instruments, Inc recommends using a qualified
licensed electrician to wire Series ULS and your application’s components.
Configure your Series ULS with ULSX ‐ CAL and use the wiring diagram button to view the appropriate
diagram. Each configuration will have its own unique diagram. The diagram above is only a sample
and should not be used as a wiring diagram.
Always use stepper relays between the sensor and external loads. For DC circuits use a catch diode
such as 1N4148, shown on the wiring diagram shown above and supplied by ULSX ‐ CAL.
Once Series ULS is configured, isolate the white and green wires from active power to prevent a
short of the configuration circuit.