Quick Start Guide
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
1
Before the installation, remove the magnetic cover from the flush mount.
2
Using the mounting template mark and drill the necessary holes in the mounting surface.
3
Adjust the 3-point in-ceiling wing using a screwdriver. Twist the screws to tighten and expand until the flush mount is secured
to the mounting surface.
4
To mount the camera to the mounting accessory, remove the dome from the camera base using the wrench included
with the camera.
NOTE:
Do not touch the lenses when handling the camera modules.
5
Pass wires through the flush mount base and make all necessary connections.
6
Secure the camera to the flush mount using the appropriate mounting screws. Refer to the table below:
Camera part number
Mounting screw size
DWC-MV82DiVT
DWC-MV82WiATW, DWC-MPV82WiATW
DWC-MV85WiATW, DWC-MPV85WiATW
25mm mounting screws
DWC-MVC8WiATW, DWC-MPVC8WiATW
DWC-MVC8Wi28TW, DWC-MPVC8Wi28TW
16mm mounting screws
3-point ceiling wings
Camera module
Flush mount
Flush mount base
7
Adjust the camera’s position and angle. Secure the dome cover to
the camera base using the screws included with the camera. See
the camera’s QSG for more information. Complete the installation
by reattaching the magnetic cover over the camera dome.
Quick Start Guide
INSTALLATION
Rev: 08/22
Camera dome cover
