DVS SpycerBox, Руководство по оборудованию

Страница: 51 / 62

A-3
2
1
3
4
5
Appendix
I
A
The system is over-
heated. If you can rule out the three above
mentioned causes, the alarm must
be due to overheating. An overheat-
ing rarely occurs, and then most like-
ly caused by too much dirt
accumulated at the ventilation holes.
Shut down the system immediately
(see section “Shutting Down the
System” on page 4-2). Afterwards
open the casing as described in sec-
tion “Opening the Casing” on
page 5-6 and clean all ventilation
holes. When finished, reassemble
the system (see section “Closing the
Casing” on page 5-6) and start it. In
case the problem persists, contact
the DVS service department.
An alarm is sounded
and the alarm LED is
off. The alarm cannot
be switched mute
with the mute but-
ton.
OR
At start-up the sys-
tem is not able to ini-
tialize a disk set, i.e.
one or more hard
disks are not recog-
nized by the system.
A hard disk or a hard
disk carrier got loose/
jammed (e.g. after
transport) or is not
mounted correctly. Shut down the system as described
in section “Shutting Down the Sys-
tem” on page 4-2. Then perform
the following: Pull all disk carriers
partially out of the chassis and after-
wards install them again. See to it
that they are pulled out and reas-
sembled correctly as described in
section “Replacing a Hard Disk” on
page 5-3. After that start the system
again.
A hard disk of the
hard disk array is de-
fective. Replace the defective disk as ex-
plained in section “Hard Disk Main-
tenance” on page 5-2.
Error Cause Solution