DVS SpycerBox Flex, Руководство по оборудованию

Страница: 68 / 84

Maintenance
 Removal of the Faceplate
5-22
SpycerBox Ultra/Flex | Hardware Guide | Version 3.1
Rohde & Schwarz DVS GmbH
5.7 Removal of the Faceplate
The faceplate of the system can be removed, for example, for trans-
ports. For this perform the following:
1. Lift the faceplate of the system (see section “Faceplate” on
page 2-6).
Beneath it you will see a cable with a jack connection that supplies the
R&S DVS logo of the faceplate with power.
2.
Unplug the jack connection.
3.
Next hold tight the faceplate and remove the hinge wires as indi-
cated in the following figure:
Figure 5-5: Removing the hinge wires
Afterwards the faceplate can be taken off.
Removing the faceplate might cause electromagnetic in-
compatibility
When operating the system without faceplate, electromagnetic in-
compatibility might be the consequence.
The system must be operated only with the faceplate in-
stalled to ensure electromagnetic compatibility.
To reassemble the faceplate reverse the above steps.
hinge wire
1 22