Overview
Overview of the Front
2-6
SpycerBox Ultra/Flex | Hardware Guide | Version 3.1
Rohde & Schwarz DVS GmbH
2.2.4 Faceplate
The faceplate covers the hard disks of the hard disk array.
Figure 2-6: Overview of the faceplate
The faceplate is built with an integrated backlit R&S DVS logo which in-
dicates the state of the system, i.e. its power-on status: If the R&S DVS
logo is illuminated, the power is turned on; if not, the power is turned
off.
The top side of the faceplate is hinge-fastened, while its bottom side is
fixed with magnets. If you need access to one of the hard disks, for ex-
ample, to replace it, you just have to lift the faceplate:
Figure 2-7: Lifting of faceplate
Then you can access the hard disks of the hard disk array (see section
“Hard Disk Array” on page 2-7).
The faceplate can be removed for transport reasons (see section “Re-
moval of the Faceplate” on page 5-22).
faceplate
backlit R&S DVS logo
Содержание SpycerBox Flex
