protector and run the treadmill at 2.5 mph. You should see the belt start to correct itself,
moving back towards the center. Repeat the above procedure until the walking belt is
centered. It may be necessary to set walking belt tension once you have completed this
procedure if the belt feels like it is slipping while walking. Refer below to the “Walking belt
slipping” instructions.
2.
Walking belt has shifted to the right:
First unplug the power cord from the surge protector. Using the hex key provided, turn the right
rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the
surge protector and run the treadmill at 2.5 mph. You should see the belt start to correct itself,
moving back towards the center. Repeat the above procedure until the walking belt is centered. It
may be necessary to set walking belt tension once you have completed this procedure if the belt
feels like it is slipping while walking. Refer below to the “Walking belt slipping” instructions.
3.
Walking belt is slipping:
First unplug the power cord from the surge protector. Using the hex key provided, turn both the left
and right rear roller adjustment bolts the same distance, usually a 1/4 turn in the clockwise
direction. Plug the power cord back into the surge protector and run the treadmill at 2.5 mph. You
should now walk on the belt to determine if the belt is still slipping. Repeat the above procedure
until the walking belt is not slipping. The tension should be just tight enough not to slip.
WARNING! Do not over tighten rollers! This will cause premature roller bearing failure!
Right and left Allen bolts are located at the rear of the treadmill.
DECK LUBRICATION:
The walking belt has been pre-lubricated at the factory. However, it is recommended that the walking board
be checked periodically for lubrication to ensure optimal treadmill performance.
Every 3 months of operation lift the sides of the walking belt and feel the top surface of the walking board as
far as you can reach. If you feel signs of silicone, no further lubrication is required. If it feels dry to the
touch, follow the instructions below.
Please use Lube ‘N Walk, or a non petroleum based silicone such as “Napa 8300” (available at most stores).
TO APPLY LUBRICANT TO THE WALKING BELT
3
Position the walking belt so that the seam is located on top and in
center of the walking board.
4
Insert the spray nozzle into the spray head of the lubricant can.
5
While lifting the side of the walking belt, position the spray nozzle
between the walking belt and the board approxinateluy6” from the
front of the treadmill. Apply the silicone spray to the walking board,
moving from the front of the treadmill to the rear. Repeat this on the
other side of the belt. Spray approximately 4 seconds on each side.
6
Allow the silicone to “set” for 1 minute before using the treadmill.
REMARK: When the treadmill is over load by any case, for the using safety
the fuse will be broken and the power will be cut off . Change a
new fuse and start again.
29
EN
