DUURA DVF1, Руководство по обслуживанию, установке и уходу, Страница: 4 / 28

INSTALLATION
LOCATION
Units represented in this manual are intended for indoor use only Be sure the location chosen has a
floor strong enough to support the total weight of the cabinet and contents. A fully loaded unit can
weigh as much as 1500 pounds. Reinforce the floor as necessary to provide for maximum loading.
For the most efficient refrigeration, be sure to provide good air circulation inside and out.
INSIDE CABINET:
Do not pack the units so full that air cannot circulate The refrigerated air is discharged at the top
rear of the unit. It is important to allow for proper air flow from the top rear to the bottom of the
unit. Obstructions to this air flow can cause evaporator coil freeze ups and loss of temperature
or overflow of water from the evaporator drain pan. The shelves have a rear turn up on them to
prevent this However, bags and other items can still be located to the far rear of the cabinet Air
is brought into the evaporator coil with fans mounted to the front of the coil
OUTSIDE CABINET:
Be sure that the unit has access to ample air Avoid hot corners and locations near stoves and
ovens It is recommended that the unit be installed no closer than 2” from any wall with at least
12” of clear space above the unit
LEVELING
A level cabinet looks better and will perform better because the doors will line up with the frames
properly Use a level to make sure the unit is level from front to back and side to side Units
supplied with legs will have adjustable bullet feet to make the necessary adjustments If the unit
is supplied with casters, no adjustments are available. Ensure the floor where the unit is to be
located is level
STABILIZING
All models are supplied with casters for your convenience, ease of cleaning underneath and
for mobility It is very important, however, that the cabinet be installed in a stable condition with
the front wheels locked while in use
Should it become necessary to lay the unit on its side or back for any reason, allow at least
24 hours before start-up to allow compressor oil to flow back into place. Failure to meet this
requirement can cause compressor failure and unit damage
Unit repairs will not be subject to standard unit warranties if due to
improper installation procedures.
ELECTRICAL CONNECTION
Refer to the amperage data on page 3, the serial tag, your local code or the National Electrical
Code to be sure the unit is connected to the proper power source
The unit must be turned OFF and disconnected from the power
source whenever performing service, maintenance functions or
cleaning the refrigerated area.
3
CAUTION
DANGER
NOTE
CAUTION
DANGER
NOTE