6
ENGLISH
•
Sanding wood decks is not recommended by Dustbane due to uneven surfaces which could lead to damage
to the machine. Some pressure treated wood found in decking contains arsenic that, when sanded, will create
hazardous dust. Dustbane assumes no liability if the machine is used on decks, and damage caused from sanding
pressure treated wood will not be warranted.
•
Do not operate this machine around fuels, solvents, fl ammable fl oor fi nishes, thinners, wood particulate or any
fl ammable materials. Cigarette lighters, pilot lights, electrical sparks and all other sources of ignition should be
extinguished or avoided. Work areas should be well ventilated.
•
Keep the power cord clear of the pad. Always lift the cord over the machine. Do not pull on the power cord in an
attempt to move the machine. This could result in electrocution.
•
Do not use machine if it has been sprayed with water or left out in the rain. This could result in a shock, injury or
electrocution.
•
Keep feet, hands, and loose clothing away from any moving parts on the machine to avoid injury. Disconnect
power cord before changing the pad or when servicing. Damage can occur to the machine or to other property
if instructions in the owner’s manual are not followed.
•
Do not operate this machine while under the infl uence of alcohol or other drugs.
•
Never allow children under age 18 to operate this machine.
•
Unplug machine from power source before adjusting height of handle or changing pad.
•
Servicing this machine while still connected to a power source could lead to electrocution or fi re. Before
performing machine service or maintenance, disconnect the machine from its power source. Operating this
machine with a damaged power cord could lead to electrocution or fi re. Cord should remain clear of moving
parts during operation. Never use the cord to navigate the machine.
Integra-D Troubleshooting Guide
CAUTION: Always disconnect power cord before servicing.
WARNING: Repairs should only be performed by an authorized service center.
PROBLEM:
Machine won’t start
CAUSE
SOLUTION
1. Machine is not plugged
1. Check wall outlet and motor connection
2. Socket breaker has been tripped
2. Reactivate breaker
3. Motor breaker has been tripped
3. Press manual reset on motor box
4. Faulty receptacle
4. Move to new receptacle
5. Defective switch / wiring
5. Contact Dustbane dealer
PROBLEM:
Runs unpredictably
CAUSE
SOLUTION
1. Faulty receptacle
1. Move to new receptacle
2. Faulty extension cord
2. Use new 10 gauge extension cord less than 25 feet
3. Defective switch
3. Contact Dustbane dealer
4. Defective motor
PROBLEM:
Fuse / Breaker Trips
CAUSE
SOLUTION
1. Excessive weight for application
1. Reduce machine weight
2. Faulty Breaker
2. Breakers in electrical panel need replacement by electrician
3. Extension cord too long
3. Move machine to new receptacle closer to worksite
