Durr EcoGun 651, Руководство по эксплуатации

Страница: 4 / 20

4
Eco Gun 651
SAFETY REGULATIONS
Earthing of the Equipment
Due to flow rate of the liquid at the high spraying pressure the
electro-static charge may be developed on the spraying gun under
certain circumstances. It may result in sparks of flames due to
discharging. To prevent this phenomena the spraying device must be
earthed. In addition the conductive connection (potential equalizing
cable) must be installed between the high-pressure device and the
gun during processing of the materials with the ignition point below
21°C (NITRO etc.).
Resistance to Pressure
All elements forming part of the high-pressure section of the
automatic spraying gun comply by their operating pressure with the
maximum pressure specified by the technical parameters.
Manipulation with High-Pressure Valve
The high-pressure gun operates with very high pressures.
Therefore never put your hand and/or fingers before the gun and
never focus the gun to the body. During assembly or disassembly of
the nozzle, resp. during cleaning or during any interruption of the
work proceed very carefully and secure the gun to prevent accidental
start (disconnection of the control air). This is to prevent accidental
start of the gun and possible subsequent injury.
Injury of Operator
The injury caused by the high-pressure liquid may be very serious.
In case of injury immediately seek the doctor and notify him/her on
type of material causing the injury.
Personal Protection at Work
During spraying and handling with the application materials, as
well as during cleaning of the equipment adhere to instructions of
manufacturers of the materials; use suitable personal protective
equipments (clothes, gloves, respirators, protection masks, resp.
breathing devices, protecting creams etc.) to protect the skin and
respiration tracts.
Although very small amount of fog is generated during the high-
pressure spraying, the spraying procedure cannot be considered for
the fog-free one. Even if the air contains very low number of the
particles, it is necessary to exhaust the solvent vapours, which are
especially dangerous.
Equipment Cleaning
During cleaning of the equipment with the flammable liquids it is
necessary to prevent the back-spraying into the closed vessel, as the
liquid stream can produce the explosive mixture of the gas and air.