Durr Dental 4852-54, Инструкция по установке и эксплуатации

Страница: 28 / 48

Network configuration
Various options are available for network configu-
ration:
ü Automatic configuration via DHCP (recom-
mended).
ü
Automatic configuration via Auto-IP for direct
connection of unit and computer.
ü
Manual configuration.
❯
Configure the network settings of the unit using
the software or, if available, the touch screen.
❯
Check the firewall and release the ports, if
applicable.
Network protocols and ports
Port Purpose Service
45123 UDP,
45124 UDP Unit recognition and
configuration
1900 UDP Service detection SSDP /
UPnP
502 TCP Unit data
514
1)
UDP
Event protocol data Syslog
22 TCP Diagnosis Telnet,
SSH
123 UDP Time NTP
1) The port can vary depending on the config-
uration.
10 Adjustment options
10.1 Adjustment of the switch-
on/cut off pressure
WARNING
Risk of explosion of the pressure ves-
sel
The pressure vessels used in the com-
pressors are designed to withstand
continuous pressure changes of 2 bar
and can be used continuously under
these pressure changes.
❯
For load changes > 2 bar (max. per-
missible: 3 bar), comply with the maxi-
mum load change cycles specified in
the operating instructions of the pres-
sure vessel.
The pressure adjustment is performed in standby
mode.
❯
Standby button: press for at least 2 sec-
onds.
❯
Service key: press for at least 2 seconds.
The blue LEDs in the operating panel flash.
They are touch-sensitive and can be adjusted
accordingly.
5
6
7
8
9
bar
The blue LEDs in the operating panel flash. They
are touch-sensitive and can be adjusted accord-
ingly.
The pressure adjustment is performed in
0.5 bar increments by touching the LED.
The blue LEDs in the operating panel flash. They
are touch-sensitive and can be adjusted accord-
ingly.
❯
Touch the first flashing LED with your finger
and swipe to the required
switch on pressure .
❯
Touch the last flashing LED with your finger and
swipe to the required
cut off pressure .
Assembly
26 4852100006L02 1907V005
EN