Dürkopp Adler M-TYPE H867, Руководство по обслуживанию

Страница: 74 / 92

Thread cutter
72 Service manual H867 Version 00.0 - 08/2013
7. Move the control cam (4) such that the distance between its widest
extent (6) and the roller (3) is 0.1 mm at most.
8. Tighten the control cam setscrews (5).
9. Loosen the clamping screw (8) on the actuating lever (7).
Figure 59: Aligning the thread-pulling knife sideways - Part 2
10.Turn the thread-pulling knife (12) such that the circle mark is exactly
next to the tip of the counter-blade (11).
11.Tighten the clamping screw (8) on the actuating lever (7) such that the
actuating lever (7) has no axial play.
12.Loosen the four setscrews (2) on the hook clamping ring (1).
13.Push the hook clamping ring (1) to the right as far as it will go and against
the control cam (4).
14. Important: Check the loop stroke position.
(  Section 11.2 Setting the loop stroke position , page 47)
15.Tighten the four setscrews (2) on the hook clamping ring (1).
6
1
2
4
3
5
7
8
4
3
9
<
0
,
.
+
^
(10) - Counter-blade screw
(11) - Counter-blade
(12) - Thread-pulling knife (13) - Fastening screw
(14) - Lower thread clamp
(15) - Lower thread clamp screw
(1) - Hook clamping ring
(2) - Setscrews
(3) - Roller
(4) - Control cam
(5) - Control cam setscrews (6) - Widest extent
(7) - Actuating lever
(8) - Clamping screw
(9) - Solenoid