62562
7
Instruction Manual
Duren Tools
T: 01582 484875 E: [email protected]
www.duren.co.uk
Declaration of Conformity
We declare that the equipment detail below, to the best of our knowledge and
ability, complies with the following Directive.
Machinery Directive - 2006/42/EC and amending Directives
Equipment Description
75mm Palm Sander
Part Code
62562
7
Distributed in the EU by
Fast Mover Tools Ltd
Address
Unit 1 Frenchs Avenue
Dunstable
Bedfordshire
LU6 1BH
United Kingdom
The following Transposed Harmonised Standards have been applied in the
design and construction of this equipment:
The manufacturer and the distributor, stated above, hold the Technical Construction File for this
equipment.
Signed on behalf of the distributor
(the responsible person)
…………………………………………
Name:
Brian Moffitt
Position:
Director
Date and Place:
01/
03
/1
6
, Dunstable, UK
Please look after the environment, dispose of all packaging in a responsible way.
Always dispose of tools in accordance with local authority guidelines.
© 201
6
Fast Mover Tools Ltd. This document is copyright and is not to be copied, circulated, distributed or shown
to anyone other than the intended recipient without the express permission of Fast Mover Tools.
625624_Product Instructions 27/03/2014 08:30 Page 8
EN ISO 11148-3:2012 Part 8: Hand held non – electrical power tools- safety requirements –
sanders and polishers
3/8” Reversible Air Drill
321265
31/01/18, Dunstable, UK
321265
PLEASE KEEP THIS MANUAL SAFE FOR FUTURE REFERENCE
Duren Tools
T: 01582 484875 E: [email protected]
www.duren.co.uk
4
It is strongly advised that you always use a Whip Hose/Leader Hose in combination with
Quick Release Couplings. See
Fig. 2
for recommended setup.
5
Water in the air supply will cause the internal bearing of the tool to rust and eventually
seize.
6
Make sure that your airline is free from water at all times.
7
Always select the correct sanding disc grit for the job.
Tools Included with your Sander
1 x High Flow Male Air Fitting
Maintenance
1
If the air supply is not lubricated sufficiently it will be necessary to lubricate the tool
directly. This can be done by disconnecting the air hose and pouring in 5ml of air tool oil
into the Air Inlet. Read safety data sheet or instructions on use of oil to ensure safe
usage. These can be obtained from your supplier.
2
Replace worn or damaged parts using genuine parts only.
3
Store tool in a dry area, do not allow tool to be immerse in water or used/stored in wet
conditions.
625624_Product Instructions 27/03/2014 08:30 Page 5