Duratuf Kinloch, Руководство по сборке

Страница: 38 / 43

Page
36
Dura
®
LIFESTYLE LIFESTYLE
Kinloch
• Position bracket (B) centre on outer stud, approximately
140mm up from bottom of lintel and 80mm from inside of
door opening to outside of bracket.
• Mark 2 hole positions using the bracket’s top and bottom
slots.
• Drill both holes, then attach brackets using 50mmx10mm
coach screws and 10mm washers.
• Install second bracket as per above and make sure it is level
with the first bracket.
6.1 Brackets installation
6.2 Door placement on brackets
Centralise shaft on roller door and fit plastic clamp onto shaft at one
end to ensure shaft stays centralised.
• Do not cut plastic yet.
• Using 2 persons and correct lifting techniques, lift door onto
brackets (right way around, so door will roll down from the front of
the opening).
• Immediately loosely fit “U“ bolts (K), saddles (L), washers and nuts
(M) to the brackets in position shown.
• Fitting “U“ bolts eliminates the door falling from the brackets. (Do
not tighten yet.)