15
15
15
SPOUTING
• If shed has an optional downpipe kit, fi t end caps now.
• Using six rivets per end, fi t and rivet end caps to each end of spouting and
silicone end caps to ensure there are no leaks.
• Nail assembled spouting to top of top plate, using four 30mm clouts as shown.
(Note - spouting will overhang corner fl ashing by approx 20mm, spouting will
always be on the lower top plate.)
• Determine position of downpipe and mark a 30mm diameter hole in underside
of spouting. (Note - hole needs to be centrally above corner fl ashing and can
be at either end.)
• Mark a 30mm diameter hole ensuring hole is as close as possible towards the
corner fl ashing to allow enough clearance for downpipe cover fl ashing.
• Cut out hole by drilling a few small holes then using tin snips to enlarge hole to
correct size.
• Fit dropper through hole and tighten nut on dropper. Silicone around top of
dropper. Attach the hose to dropper with hose clip.
• Position downpipe cover fl ashing over hose and rivet to wall cladding.
