6
6
6
RADIO SYSTEM CHECK
STEERING
DUAL RATE
TRANSMITTER
ANTENNA
STEERING
TRIM
THROTTLE
TRIM
THROTTLE
BRAKE
ON/OFF
SERVO
REVERSING
POWER LED
1. Fully extend the transmitter antenna.
2. Turn the transmitter on, then turn the
receiver on.
3. The transmitter wheel will move the
front wheels of the car left or right. If
the wheels turn the incorrect direction,
change the servo reversing switch.
4. When running, adjust the steering trim so that the car
tracks straight.
5. Pull the throttle trigger to make sure the carburetor opens
fully and the throttle linkage functions without binding.
6. Adjust the throttle trim until the carburetor is at the idle
position. Always adjust the idle speed with the idle stop
screw on the car, not the throttle trim.
7. Push the trigger and roll the car to make sure the brakes
are applied.
• USE THE STEERING DUAL RATE KNOB TO INCREASE
OR DECREASE THE TOTAL STEERING AMOUNT!
ALWAYS CHECK THE RADIO
OPERATION
BEFORE
EACH RUN
!
MAKE SURE NOBODY ELSE
IS ON YOUR CHANNEL
!
• Decal the body to your liking. Use the
photos on the box as a reference.
• Install the body onto the chassis
using four body clips.
