Duratrax Micro street force RTR, Руководство по сборке и эксплуатации

Страница: 4 / 20

❏
5. Turn on the transmitter using the on/off switch (see step
#3). The red light on the transmitter should light up. If there is
no light on, turn the transmitter off and check to ensure that the
batteries are making contact with the metal contacts in the
battery holder and are installed correctly. Turn the transmitter
on. If the red light appears, turn off the transmitter. If the red
light blinks, the batteries are low and should be replaced.
❏
6. Straighten the receiver antenna. Route the antenna
under the upper deck of the chassis and up through the
antenna mount located at the rear of the car. Run the
receiver antenna wire through the included antenna tube.
DO NOT CUT OR COIL THE ANTENNA WIRE. Press fit the
antenna tube into the antenna mount hole. TIP: Run the
antenna wire through your finger to straighten out the kinks
before running through the antenna tube. TIP: Applying a
small amount of soap and water to the antenna wire will
help lubricate the wire for threading into the antenna tube.
❏
7. Remove the body pin from the battery holder and insert
the charged 6-cell battery pack into the chassis.
❏
8. Re-install the battery clip onto the battery holder.
❏
9. Program the ESC. Start by centering the trim knobs on
the transmitter. Turn the transmitter “on” then turn the ESC
“on.” Push and hold the set button until the red and green
LEDs begin to flash. Push and hold the set button again until
the green LED begins to flash. Pull the throttle trigger to full
throttle and hold it. Push and hold the set button again until
the red LED begins to flash. Push the throttle trigger all the
way forward and hold it then push the set button one last
time and release the throttle trigger to neutral. Both the red
and green LEDs should be constantly lit. The ESC should
be programmed at this time.
❏
10. Decal the body as desired and install it onto the
chassis, securing it in place with the four included body clips.
❏
11. The transmitter features an adjustable steering rate
knob labeled “D/R” on the top of the transmitter. Turning it
fully clockwise will give you the greatest amount of steering
travel. Turning it counter clockwise will reduce the amount of
steering travel.
❏
1. Fully extend the transmitter antenna.
❏
2. Turn on the transmitter and check to make sure the
transmitter LED is lit. If it is blinking or not lit, check the batteries.
❏
3. Turn on the ESC.
❏
4. Check that the steering is functioning properly.
❏
5. HAVE FUN!
❏
6. Once the car begins to slow down drastically when
running, it is time to stop the car. This is a sign that the
battery is getting low.
❏
7. Always turn off the ESC before the transmitter to
prevent your car from running away.
❏
8. Turn off the transmitter.
❏
9. Carefully collapse the transmitter antenna.
❏
10. Remove the battery from the car and allow it to fully
cool before recharging.
RUNNING THE MICRO STREET FORCE
7.2V Ni-C
d
600mAh
4