E) Push the throttle rod with your finger so that the carb will
be nearly closed.
F) Move the throttle spring next to the rod connector.
G) Tighten the inner 2mm collar next to the throttle spring
without compressing the spring.
H) Tighten the outer collar on the throttle rod right next to the
rod connector.
I) Replace the throttle servo arm screw.
❏
Step 1. From bag P001, remove the fuel line, air cleaner,
and tie-strap.
❏
Step 2. Remove the fuel tank by taking out the two
screws on the bottom of the chassis.
❏
Step 3. Cut the fuel line in half. Route one of the lines
from the nipple on the top of the muffler to the top of the fuel
tank. Route the other fuel line from the nipple on the
carburetor to the bottom of the fuel tank. Ensure that the fuel
line is not kinked anywhere along the line. You may have to
shorten the line to eliminate kinks.
❏
Step 4. Soak the air cleaner with an air filter oil, light
machine oil, or in a pinch, shock oil. Thoroughly soak the
foam element and squeeze out the excess. Place the air
cleaner on the top of the carb. Tighten a tie-strap around the
neck of the air cleaner to hold it on the carb throat and cut
off the excess portion of the tie-strap.
❏
Step 5. Re-install the fuel tank.
SECTION 6: PREPARE THE ENGINE
9
