❏
Step 4. Attach the radio tray mounts as shown to the
chassis with (4) 3 x 8mm self-tapping screws.
❏
Step 5. Plug the steering servo, throttle servo, and switch
into the receiver. See your radio instructions to determine
which channel is steering and which channel is throttle.
(The radio tray is shown temporarily inverted.)
❏
Step 6. Fit the antenna tube through the radio tray and
press fit the antenna tube into the radio tray post. Thread
the receiver antenna through the antenna tube. The
receiver antenna wire will be considerably longer than the
antenna tube.
DO NOT CUT OR COIL THE ANTENNA.
Use tape to attach the leftover antenna wire to the outside of
the antenna tube.
❏
Step 7. Attach the radio tray to the radio posts with (4)
3 x 8mm self-tapping screws.
❏
Step 8. Remove from your radio system the 4-cell receiver
battery holder and install (4) “AA” batteries. Plug the
connector on the receiver battery holder into the connector on
the switch. Make sure the switch is in the OFF position.
❏
Step 9. Place the receiver battery holder on top of the
radio tray and wrap a tie-strap around the receiver and the
receiver battery. Tighten the tie-strap until the receiver
battery is firmly in place. Cut the loose end of the tie-strap
leaving some excess to allow for removal of the strap for
battery replacement.
6
