12
Rear Shock Tower, Rear Transmission Plate,
Rear Bulkhead, Rear Suspension Arm
1. Attach the rear chassis plate (41) to the chassis (1) using
four 3x10mm round head screws (C).
2. Attach the rear suspension arms (36,37) to the rear chassis
plate using the inner rear hinge pins (97).
3. Secure the front of the inner rear hinge pins in place using
two 2.5mm e-clips (S).
4. Install the rear shock tower (40) and transmission brace (42)
onto the chassis using four 3x12mm round head screws (D).
Note: Make sure the screws pass through the shock
tower, chassis and into the transmission brace.
5. Install two long ball studs (30) into the appropriate holes
in the transmission brace.
Note: The stock setting is the
lower inner holes. Make sure that the ball studs are in
the same hole location on both sides.
40
42
41
S
S
37
36
97
97
30
30
1
C
C
C
C
D
D
D
D
108
108
58
58
S
S
107
9
79
22
36
37
123
81
26
58
58
S
S
107
108
108
9
22
79
123
81
27
Rear Hub, Rear Axles
1. Install two 5x10mm bushings (108) in both of the rear hubs (26,27).
2. Install a short ball stud (81) into the center hole of the rear hubs.
3. Place one 3mm plastic spacer (58) on each side of the rear hubs.
Secure the rear hubs to the rear suspension arms (36,37) with the
3mm outer rear hinge pins (107).
4. Secure the outer rear hinge pins with 2.5mm e-clips (S).
5. Install the rear axles (9) through the bushings in the hubs.
6. Install a spring pin (123) into each of the rear axles.
7. Install one joint spring (22) into each of the axles.
8. Install a dogbone (79) into each of the axles.
