8
OPERATION - AUDIBLE CONTINUITY TEST
•
Connect the red test lead to the “VΩmA” jack and the black test lead to the “COM”
jack.
•
Set the range switch to “ ” position.
•
Connect the test leads to the two points of the circuit to be tested. If continuity
exists, the built-in buzzer will sound.
BATTERY & FUSE REPLACEMENT
•
If the “ ” symbol appears on the display it indicates that the battery shouid be
replaced.
•
To replace a battery and fuse (200mA/250V) remove the two screws in the bottom
of the case.
•
Before opening the case, always disconnect the test leads from all energised
circuits.
•
Remove the old fuse or battery and replace it with a new one of the same
specification.
•
Be careful to observe the battery polarity.
•
Never use the meter unless the back cover is in place and securely fastened.
CLEANING
•
Use a soft, clean, dry cloth to clean the meter.
•
Do not use any chemicals, abrasives or solvents that may damage the meter.
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
This symbol indicate that separate collection of Waste Electrical and
Electronic Equipment (WEEE) or waste batteries is required. Do not dispose
of these items with general household waste. Separate for the treatment,
recovery and recycling of the materials used. Waste batteries can be
returned to any waste battery recycling point which are provided by most
battery retailers. Contact your local authority for details of the battery and
WEEE recycling schemes available in your area.
Made in China. PR2 9PP
V 1.0
