Duratech HD-8 V Series, Руководство по эксплуатации

Страница: 58 / 93

50
HD-8 SERIES V O P E R A T I N G I N S T R U C T I O N S
Section 4: Engine Maintenance Section 4: Engine Maintenance
Section 4: Engine Maintenance Section 4: Engine Maintenance
Section 4: Engine Maintenance
Engine oil level, engine coolant level, air filters, and fan belt tension should be checked daily. Follow the engine
manufacturer’s recommendations for the replacement of parts and fluids, and follow the manufacturer’s recommended
maintenance schedule . Engine specifications should be found in the Operation and Maintenance manual for the
engine.
WARNING: All debris, wood chips, and combustible or ignitable material should be cleared from the
engine compartment daily or more often as conditions warrant. When cleaning the engine
compartment, pay particular attention to the top of the engine.
Section 5: Section 5:
Section 5: Section 5:
Section 5: Gener Gener
Gener Gener
General Maintenance al Maintenance
al Maintenance al Maintenance
al Maintenance
WARNING: Before servicing machine, read the Service and Maintenance section of the Safety
Instructions.
IMPORTANT: If for any reason arc welding is to be done, always ground rotor to frame of
machine to prevent arcing in bearings.
Precautions are required for welding on machines with electronic components. Electronic components including but not
limited to: radio receiver, electronic governor, and ABS controllers.
Proper welding procedures are necessary in order to avoid damage to the components, their sensors, and associated
components.
If at all possible, the part that is to be welded should be removed from the machine for welding.
If removal of the part is not possible, the following procedure must be followed when welding on a machine that is
equipped with electronic components. This procedure is considered the safest and should provide minimun risk of
electronic component damage.
5.1 Welding Procedure 5.1 Welding Procedure
5.1 Welding Procedure 5.1 Welding Procedure
5.1 Welding Procedure