56
Installation of the outdoor unit
• The outdoor unit should be installed on a solid wall and fastened securely.
• The following procedure must be observed before connecting the pipes and connecting
cables: decide which is the best position on the wall and leave enough space to be able
to carry out maintenance easily.
• Fasten the support to the wall using screw anchors which are particularly suited to the
type of wall.
• Use a larger quantity of screw anchors than normally required for the weight they have
to bear to avoid vibration during operation and remain fastened in the same position
for years without the screws becoming loose.
• The unit must be installed following the national regulations.
Outdoor unit condensed water drainage
The condensed water and the ice formed in
the outdoor unit during heating operation can
be drained away through the drain pipe.
1. Fasten the drain port in the 25 mm hole
placed in the part of the unit as shown in
the picture.
2. Connect the drain port and the drain
pipe. Pay attention that water is drained
in a suitable place.
Electrical connections
1. Take the cover away.
2. Connect the cable wires to the terminal
board using the same numbering as in
the indoor unit.
3. For the electrical connections, see the
wiring diagram on the back of the cover.
4. Fasten the cables with a cable-clamp.
5.
An efficient earth connection must be en
-
sured.
6. Replace the covers.
Содержание 10028499
Страница 1: ...10028499 10028500 Klimaanlage Splitger t...
