STEP A6: INSERT PRIVACY PICKETS
Starting on one end, insert privacy pickets into top slot of middle rail and end channels. Continue across the panel inserting the
remaining pickets and interlocking the (T&G) tongues and grooves of the pickets securely
(Fig. A3).
NOTE:
If post spacing is less than 8’ on center, you can cut the picket board on one side. The cut side of picket always goes against
the post
(Fig. A3b).
ASSEMBLE AND INSTALL SECTIONS
Top Rail
Bottom Rail
Middle Rail
Pickets
STEP A7: INSTALLING TOP RAIL
Install top rail into top hole of the post, bottom groove side down at an angle while lowering the top rail bottom groove onto
pickets, sliding top rail as far as possible into the first post
(Fig. A4)
.
Ensure the pickets are fully engaged on both end channels, top rail, and middle rail slots.
STEP A5: INSTALL END CHANNEL
Center the end channel on the post between the top and middle rail holes. Position the flat side of the end channel against the post
and secure the channels to the posts using 3, #8 x ¾” stainless steel self tapping screws
(Fig. A1).
Post
Property of Duramax Building Products © September 2021
STEP A4
STEP A5
STEP A6
STEP A3
STEP A7
STEP A2
STEP A1
End
Channel
End
Channel
Pickets
Mount
Centered Vertically
the End Channel
to the post.