Duraline Systems DuraSprayer, Руководство по эксплуатации

Страница: 7 / 28

Page 3
With a 28 oz. tank capacity it is VERY IMPORTANT NOT TO
OVERFILL WITH PRODUCT. The tank should only be about
80% full or about 20 oz.
4. Replace Fill Cap.
Turning the cap clockwise, hand-tighten until firmly secured.
5. Plug in / Turn on Power.
Plug the DuraSprayer™ into a three-prong grounded, 110/115-volt
electrical source. Use a three-prong grounded heavy-duty extension
cord, not longer than 50 feet, when operating this unit (Cord Not
Included). Remove Red Tip Protector Cap. Switch the unit to the ON
position using the Toggle Switch on top of unit.
6. Adjust Regulator.
To adjust regulator, start by unlocking the safety lock located on the
adjustment knob by pulling up on the knob. If a red ring is present, lift
up on the red ring to unlock. Turn the knob slowly clockwise until the
0-30 psi back mount gauge reads 10 - 12 psi.
Note: The higher the pressure on the 0-30 gauge, the larger the
disinfectant particles will be. A higher pressure will be required
when working overhead (above 6-8 ft.) to compensate for the effects
of gravity. Adjust in 1 or 2 lb. increments to achieve desired flow and
particle size.