-
5
-
DECAL PLACEMENT
ARM HOIST & BODY INSTALLATION
DECAL PLACEMENT & SERIAL
NUMBER PLATES LOCATION
BEFORE PLACING THE DUMP UNIT INTO OPERATION, THESE DECALS MUST BE PLACED IN
THEIR PROPER POSITION.
CAUTION DECAL #212A1103 IS 3-1/2” X 9”. IT MUST BE PLACED ON CHASSIS FRAME
AS SHOWN - ONE ON EACH SIDE.
WARNING DECAL #212A735 IS 1-7/8” X 4-1/2”. IT MUST BE PLACED ON THE DASH
ABOVE CAUTION DECAL #212A1104 THAT IS 1-7/8” X 4-1/2”.
INSTRUCTION DECAL #212A1166 MUST BE PLACED ON DASH NEXT TO THE CAUTION AND
WARNING DECALS AS SHOWN IN THE SKETCH.
CAUTION DECAL #212A1131 IS 4-3/4” X 5”. IT MUST BE PLACED ON THE DUMP BODY
ABOVE THE SERIAL NUMBER PLATE AS SHOWN IN THE SKETCH.
IF THE INSTALLATION HAS LEVER CONTROLS USE DECALS #212A1164. SELECT THE
DECAL THAT CORRESPONDS TO THE DIRECTION OF TRAVEL FOR PTO LEVER IN AND OUT
AND FOR HOIST CONTROL UP AND DOWN.
IF THE INSTALLATION HAS CABLE CONTROLS, YOU WILL USE #212A1167 DECAL FOR
HOIST CONTROL AND #212A1168 DECAL FOR PTO CONTROL. BASED ON THE CONTROLS
INSTALLATION FOR THIS SPECIFIC HOIST, YOU WILL HAVE TO SELECT AND INSTALL
THE PTO DECAL (212A1168-1 or 212A1168-2) THAT CORRESPONDS TO THE DIRECTION
OF TRAVEL OF THE CABLE CONTROLS FOR THE PTO IN AND OUT.
6
1
2
4
3
5
