Duracell inverter 1000, Руководство пользователя

Страница: 32 / 65

Installing the Duracell
975-0347-01-01 3–13
To connect the chassis ground terminal to a grounding point:
• Recreational Vehicle: Connect the
CHASSIS GND
screw to the
vehicle’s chassis using a recommended 8AWG minimum copper wire
(if insulated then green insulation with or without one or more yellow
stripes) or larger.
Chassis Ground Screw
We recommend that you attach the cable to the chassis ground screw with
a ring terminal. This procedure will ensure that the wire does not slip off
the chassis ground screw.
To connect the cable to the chassis ground screw:
1. Make sure the inverter’s On/Off switch is in the Off position.
2. Remove chassis ground screw and star washer using #2 Phillips
screwdriver.
3. Strip 1/2 inch (13 mm) to 3/4 inch (19 mm) of insulation from one
end of each cable.
4. Attach the ring connector that will join the cable to the chassis ground
screw. The connector you use must create a permanent, low-
resistance connection. (See “Materials” on page 3–10.)
5. Fit the chassis ground screw through the star washer and the ring
connector back into the screw opening.
6. Tighten the chassis ground screw.
Connecting the DC Cables
Consult Figure 3-1, “Configuration for Normal Loads” on page 3–2, or,
Figure 3-2, “Configuration for Heavy Loads” on page 3–3, for additional
details that are specific to your installation.
To connect the DC cables:
1. Make sure the inverter’s On/Off switch is in the Off position.
2. Strip 1/2 inch (13 mm) to 3/4 inch (19 mm) insulation from each end
of each cable. The amount stripped off will depend on the terminals
chosen.
3. Attach the connectors that will join each end of each cable to the
battery, Disconnect/Battery Selector switch, and fuse block. The
connectors you use must create a permanent, low-resistance
connection.
Duracell1000.book Page 13 Friday, September 7, 2007 1:47 PM