DURA NIGHT TUNDRA, Инструкция по эксплуатации

Страница: 11 / 28

SETTING UP YOUR MODEL:
1. With your receiver installed and all servos plugged into their corresponding channels, connect the
flight battery to the ESC to power up the electronics. With the model now armed, ensure all
servos are centered and all control surfaces are level. If not, adjust by screwing the control
clevises by hand, clockwise or anti-clockwise until the control surfaces are level as shown.
2. Check all control surfaces are moving in the correct direction with the correct stick input (see below).
Roll left
Roll right
Pitch up
Pitch down
Yaw left
Yaw right
Aileron
(Roll)
Elevator
(Pitch)
Rudder
(Yaw)
Note: For safety reasons, it is advised that this is done with the prop removed from the model.
Aileron Elevator Rudder
8