Duplo DC-545 HCEX, Инструкция по эксплуатации

Страница: 54 / 90

53
1
5
Manual
Programming - DC545 HCEX
Before programming a job carefully measure,
in millimeters, the required slits, cuts and
creases. See the Figure 1 for reference and
Figure 2 for a detailed description of each
function.
Record the values in “Customer Programed
Jobs”. Remember that all measurements,
except MARK 1, are in millimeters.
Familiarize yourself with the following illustra-
tions and instructions to make the program-
ming process easy and trouble free.
IMPORTANT NOTES:
There are a total of five slitters. Two slitters are
for the margins and the remaining three
slitters are for the center of the sheet.
There is a guillotine cutter that performs cuts
perpendicular to the line of the paper travel.
There is creasing unit that performs creases
perpendicular to the line of the paper travel.
PAPER FEEDING DIRECTION
Slit
Cut
Reg. Mark
(Optional)
Bar Code
(Optional)
Crease
Manual Programming - DC545 HCEX
This chapter describes how to manually program the Docu Cutter.
The Docu Cutter is manually programmable with 80 sets of job dimensions or program numbers. Each set
of dimensions are stored and recalled by a program number. (
a
P.45, “Factory Preset Jobs”)
Chapter
5
Prior to Programming a Job
P–01? (01––80)
OK?––>SET
Program
Number
Figure 2
Figure 1
Docu Cutter(HCEX) 5_53-69 03.12.8, 3:11 PM 53