Dunlop FILL&GO, Руководство по эксплуатации

Страница: 18 / 26

47
GB
2A
WARNING:
Note that for safety reasons you may not drive faster than 80 km/h (50 mph)
with a tire that has undergone temporary repair.
Then drive for approx. 10 minutes with the vehicle to distribute the sealant in the tire and
thus seal the tire from the inside. Then check the tire air pressure again by connecting
the fill hose of the electrical air pump to the valve. You do not need the 12 V power cable
for this, nor does the air pump have to be switched on. The current tire pressure is indi-
cated automatically.
2A
WARNING:
If tire air pressure has dropped again after approx. 10 minutes, you have to infla
-
te tire again and continue driving for approx. 10 minutes. To do this, connect the 12 V power
cable of the air pump to the 12 V socket or the cigarette lighter in your vehicle again and start
the engine (as described under section 8 and 9).
2A
WARNING: If the required tire air pressure is not achieved after the 2nd attempt, the tire
may be too badly damaged and provisional temporary repairs impossible. In this case,
you should contact a breakdown service or specialist workshop without delay.
If the air pressure remains stable, you can continue driving at a max. speed of 80 km/h
(50 mph) to the next workshop. Inform the workshop about the temporary tire repair with
the sealant.
12