DTSL3/FR MKII USER’S MANUAL
11
Chapter
Chapter
Chapter
Chapter 3
3
3
3 SAFETY
SAFETY
SAFETY
SAFETY
GENERAL
GENERAL
GENERAL
GENERAL PRECAUTIONS
PRECAUTIONS
PRECAUTIONS
PRECAUTIONS
The operator and the maintenance fitter are required to observe the prescriptions of safety regulation in force in the country of
installation of the lift.
Furthermore, the operator and maintenance fitter must:
-Always work in the stations specified and illustrated in this manual;
-Never remove or deactivate the guards and mechanical, electrical, or other types of safety devices;
-Read the safety notices placed on the machine and the safety information in this manual.
In the manual all safety notices are shown as follows:
WARNING:
WARNING:
WARNING:
WARNING:
indicates following operations that are unsafe and can cause minor injury to persons and damage the lift, the vehicle or
other property.
CAUTION:
CAUTION:
CAUTION:
CAUTION:
indicates possible danger that can result in serious injury to people and damage property.
RISK
RISK
RISK
RISK OF
OF
OF
OF ELECTRIC
ELECTRIC
ELECTRIC
ELECTRIC SHOCK:
SHOCK:
SHOCK:
SHOCK:
a specific safety notice placed on the lift in areas where the risk of electric shock is particularly high.
RISK AND PROTECTION DEVICES
We shall now examine the risks that operators or maintenance fitters may be exposed to when the vehicle is standing on the
platforms in the raised position, together with the various safety and protection devices adopted by the manufacturer to reduce all
such hazards to the minimum:
For optimal personal safety and safety of vehicles, observe the following regulations:
-Do not enter the danger areas when vehicles are being lifted. (Picture 5)
-Make sure the vehicle is positioned correctly. (Picture 6)
-Be sure to lift only approved vehicles, never exceed the specified carrying capacity, maximum height, and projection (vehicle length
and width);
-Make sure that there is no person on the platforms during up and down movements and during standing.
GENERAL RISKS FOR LIFTING OR DESCENT:
The following safety equipments are used to protect over loading or the possibility of engine failure.
In the condition of over loading, the overflow valve will open and directly return oil to the oil tank. (See Picture 7)
Each bottom of oil cylinder is equipped with antiknock valve. When the oil pipe is burst in the circuit of hydraulic pressure, the
relevant antiknock will work and limit the speediness of platform. (See Picture 8)
When the oil pipe gets bust or there's some obstacle to stop one of the platforms from lifting or lowering, another platform will stop
at the same time due to the device as picture 9.
Picture 6
Picture 9
Picture7
Picture 8
All manuals and user guides at all-guides.com
all-guides.com
