Version 08.2017 | Page/ Seite 13
www.dunkermotoren.com
CORRECTIVE MAINTENANCE
The corrective maintenance by the user is limited to the following items:
• Power and Sensor cable assembly
• Thrust rod
• Forcer
• Encoder readhead (integral cable)
CABLES
If a power or sensor cable needs to be replaced, it will be necessary to change the complete cable assembly.
Note.
It is not possible to replace an encoder cable. If an encoder cable needs replacing, the complete encoder
assembly will have to be replaced. See ENCODER READHEAD on page 22 in this chapter.
CAUTION. If the optional Renishaw encoder is fitted, it has an integral cable
that also runs through the drag chain. Take care not to damage this item when
releasing the other cables.
Removal
•
Disconnect the cable assembly from the Accelnet Micro Panel Amplifier, if connected.
• Unclip the covers of all links in the drag chain. These are shown coloured green in Figure 3.1.
Link covers
identified by
green highlight
Figure 3.1
•
They can be removed as a single item by progressively pulling up the tongue of the first cover until all are
unclipped, see Figure 3.2.
Link covers
removed
Figure 3.2
