Dunham-Bush WCFX 10, Инструкция по установке, эксплуатации и обслуживанию

Страница: 58 / 64

Display address
Setting……… : 17
I/o Board address: 01
P:01 Adr Priv/Shared
Trm1 17 Pr
Trm2 32 Sh
Trm 3 None --- OK? NO
Display address
Setting……… : 18
I/o Board address: 02
Terminal config
Press ENTER
To continue
Terminal config
Press ENTER
To continue
P:02 Adr Priv/Shared
Trm1 18 Pr
Trm2 32 Sh
Trm 3 None --- OK? NO
Display address
Setting……… : 19
I/o Board address: 03
Vision 2020i
5 sec
4
.
0 ELECTRICAL
4.9.2 Addressing the Vision
2020i DBG1 terminal
At the Vision 2020i DBG1 terminal, hold
simultaneously the last three keys on the lower
right corner of the Vision 2020i terminal
keyboard. Hold them for at least 5 seconds.
The display will appears:
The first line is the address of the terminal display
that you are using, (for first chiller, it is 17). The
next line allows you to select the Vision 2020i
controller address (for first chiller, it is 01) that
you want to configure. Once you select the
address then press ‘enter’ button
The display will appears:
Push ‘enter’ to continue.
Then the display will appears:
Set
Trm1
,
Trm2
and
Trm3
to ’
17 Pr’
,’
32 Sh
’
and ‘
None ---
’, change the '
NO
' to '
YES
'(to
confirm and save) and press ‘enter’.
Note: Pr = Private, Sh = Share.
For multiple units with master-slave sequencing
control features, At the second chiller unit Vision
2020i terminal; repeat step 1 by holding the three
keys again. The display will appears:
The address display (18) is the correct setup for
the second chiller unit with the controller address
of two (P:02).Press ‘enter’ to confirm the settings
and the display will appears:
Set
Trm1
,
Trm2
and
Trm3
to ’
18 Pr’
,’
32 Sh
’
and ‘
None ---
’, change the '
NO
' to '
YES
'(to
confirm and save) and press enter.
At the third chiller unit Vision 2020i terminal:
Press the three keys again. Then the display will
appears:
- 58 -