To activate the internal synchronization of the projectors, press and hold the “SELECT” button 2 seconds. The display
of "PROJ." indicates a number of the page which is flashing. The display will indicate whether the internal
synchronization is active ("ON") or inactive ("OFF"). To set the value of "ON" or "OFF", press the button "B".
You can change the number of active projector 1 to 9 (each projector occupies 6 channels at once) using the buttons
"UP" and "DOWN".
Press the "SELECT" to exit the internal synchronization.
6.2.2 - Manual operation
You can use DMX controller to control the projectors manually (using sliders). This allows complete freedom of
movement and function and adapts best to specific use.
To select the manual mode, press the "B". The DMX controller will then display the number of page on which he is
located (between 1 and 9, each page having six channels, which makes a total of 54 controllable channels).
You can then use the sliders to control the DMX512 line that was connected to the device. Here is the table showing
the Number of channels according to the page:
Page
Controlled channels
1
1
a
6
2
7
a
12
3
13
a
18
4
19
a
24
5
25
a
30
6
31
a
36
7
37
a
42
8
43
a
48
9
49
a
54
6.2.3 - Setting a scene
To enter the programming mode, press “A” button for 3 seconds. The display of "PROG." indicates a number and
Info: The flashing dot shows the projector can be selected by using the buttons "UP" and
DOWN.
