Duncan 2 Humbucker, Установка курса

Страница: 11 / 13

© 2020 Seymour Duncan 11
TROUBLESHOOTING
• No sound
• Check hot lead wire connections on the 3 way switch
• Make sure the battery is connected properly. Check all battery wires.
• Buzz or hum, check ground connections. See if any ground wires came loose.
• No output, check output jack wires. There should be 3 wires connected to the output jack.
• No sound, make sure batter is connected properly. Check all battery wires.
OTHER CONSIDERATIONS.
• If your guitar has a deep curve to the carved top, tightening the pickup mounting ring screws will flex
them into place.
• Do not tug on the bridge ground wire. It usually connects to the tailpiece bushings or bridge bush-
ings. This connection can come disconnected, and it is not easy to reattach.
• Before removing them, record the pickups’ height from the top of the pickup to the top of the mount-
ing ring. That way, you’ll be close to optimal pickup height when you install the new pickups.
• Removing a Les Paul’s pickguard, keep track of which mounting screws go where. They are often
different sizes.
PRO TIP
• You can fine-tune the left/right angle of
each pickup to different heights. This can
improve the string-to-string balance.
• Make sure the pickup’s adjustable pole
screws are flush with the cover.
36. Experiment with different pickup heights.
• 3/32” is just a starting point. Use your ears
to balance the output of each pickup and
to adjust the tone of your rig.
• Take measurements every time you make
adjustments. This will help you get back to
a previous setting if needed.