Code Rev. D 20140818 (IEC)
9
lock on the door) and relocate the door to the
designated position. Then screw the bottom
hinge assembly on the left designated position
and tighten it after the door is leveled.
9.
Transfer the handles & plugs to the opposite
positions and then reassembly the ventilation
grilles if need.
DESIGN 2
– For fully integrated models
1. Remove the glass door by unscrewing the eight
lock screws
○
,3
and
○
,4
. Be careful to hold
the glass door firmly after removing the screws
and place it on a padded surface to avoid the
risk of damage.
2. Unscrew and transfer the door supporter
○
,2
to the opposite side.
3. Rotate the glass door 180
°and refit the glass
door to the opposite side. Then screw and
tighten it after the door is leveled.
DESIGN 3
– For tall models
1 2
5
6
10
1
5
3
4
1. Remove the bottom hinge
○
,1 by unscrewing
the four lock screws
○
,2. Be careful to hold the
glass door firmly after removing the screws. (Fig.
1)
2. Gently pull down to remove the glass door from
the right top hinge and place it on a padded
surface to avoid the risk of damage. Then
remove the right top hinge
○
,9. (Fig. 4)
3. Pop out the cover caps on the left side of
cabinet and use them to
cover the screw holes
on the right hand side.
4. Screw the alternative left top hinge
○
,8 ,
included in the fittings,
on the left hand side of
cabinet. (Fig. 4)
5. Unscrew and transfer door supporter
○
,10 to
the opposite side. At the same time remove the
stopper pin
○
,7 of bottom hinge to the opposite
designated position or unscrew and transfer the
hinge pin
○
,7a
of bottom hinge to the opposite
designated position.
(Fig. 5 & 3)
6. Unscrew and transfer the door adapter
○
,5
and lock catch
○
,4 to the top designated
position of glass door. (Fig. 2)
7.
Rotate the door 180° and relocate the glass door
to the designated position. Then screw the
bottom hinge on the left designated position and
tighten it. (Fig. 5)
8. Recheck and adjust the door alignment by
loosening the screws
○
,6and moving the door
adapter
○
,5. Tighten the screws
○
,6 after the
door is levelled. (Fig. 5)
DESIGN 4
– For double door models
1
2
8
9
4
5
6
7
3
3
1. Remove the bottom hinge
○
,1 by unscrewing
the four screws
○
,2. Be careful to hold the
lower glass door
○
,3 firmly after removing the
screws. And then gently pull down to remove
the lower glass door from the middle hinge and
place it on a padded surface to avoid the risk of
damage. (Fig. 1)
2. Unscrew and transfer the door adapter
○
,4
and
○
,7 to the designated opposite position of
lower glass door. (Fig. 2)
3. Remove the door adapter
○
,14 by unscrewing
the two lock screws
○
,13. Be careful to hold
the upper glass door firmly after removing the
