11
IRHS Holding Unit
Restaurant Equipment Manual
UNPACKING UNIT
Inspect the shipping carton and/or container, carefully
noting any exterior damage on the delivery receipt;
also note any damage not evident on the outside of
the shipping container (concealed damage). Contact
the carrier immediately and file a damage claim with
them. Save all packing materials when filing a claim.
Freight damage claims are the responsibility of the
purchaser and are not covered by the warranty.
•
Follow the instructions on the Carton Box for
unpacking the unit.
• Inspect unit for damage such as, broken glass,
etc.
• Report any dents or breakage to source of
purchase immediately.
• Do not attempt to use unit if damaged.
• Remove all materials from unit interior.
•
If unit has been stored in extremely cold area,
wait a few hours before connecting power.
INSTALLATION CODES AND STANDARDS
In the United States, the IRHS must be installed in
accordance with the following:
1. State and local codes.
2. National Electrical Code (ANSI/NFPA No. 70,
latest edition) available from the National Fire
Protection Association, Batterymarch Park,
Quincy, MA 02269.
3.
Vapor Removal from Cooking Equipment, (NFPA-
96, latest edition) available from NFPA.
In Canada, the IRHS must be installed in accordance
with the following:
1. Local codes.
Canadian Electrical Code (CSA C22.2 No. 3, latest
edition) available from the Canadian Standards
Association, 5060 Spectrum Way, Mississauga,
Ontario, Canada L4W 5N6.
For CE Units, the IRHS must be installed in
accordance with the following:
1. Local Codes.
2. European (IEC/CENELEC) Electrical Code.
UNIT PLACEMENT
•
Do not install unit next to or above source of heat
such as oven or deep fat fryer.
• Install unit on level counter top surface.
• Outlet should be located so that plug is
accessible when the unit is in place.
• The following minimum clearances must be
maintained between the warmer and any
combustible or non-combustible substance:
Unit
Clearance
Right Side
0mm
Left Side
0mm
Rear
OPEN
Floor
0mm
Proper airflow around unit will cool the electrical
components. With restricted airflow, the unit may
not operate properly and the life of the electrical
components may be reduced.
WARNING
ELECTRICAL SHOCK HAZARD UNIT MUST
BE SAFETY GROUNDED, EARTHED.
DO NOT MODIFY, DEFEAT ELECTRICAL
CONNECTIONS OR ALTER PLUG.
ELECTRICAL CONNECTIONS
BEFORE CONNECTING THE
UNIT TO THE POWER SOURCE, VERIFY
THAT THE VOLTAGE AND PHASE OF THE
POWER SOURCE ARE IDENTICAL TO THE
VOLTAGE AND PHASE INFORMATION ON
THE DATA LABEL.
THE MAIN SWITCH ON
APPLIANCE IS FOR STANDBY POWER
USE ONLY. FOR ALL POLE DISCONNECT
REMOVE PLUG FROM WALL OUTLET.
: IF THE SUPPLY CORD IS
DAMAGED, IT MUST BE REPLACED BY
A SPECIAL CORD OR A SPECIAL CORD
ASSEMBLY AVAILABLE FROM DUKE
MANUFACTURING CO. OR ITS SERVICE
AGENT AND MUST BE REPLACED BY
DUKE OR OTHER QUALIFIED PERSONNEL
IN ORDER TO AVOID AND POTENTIAL
HAZARDS.
INSTALLATION
