This manual can be modified without any advice
2
RX2AP V2.4
RX2 AP: 2 channels wireless receiver
Warning:
THE INSTALLER TECHNICIAN MUST FOLLOW THE NORMS OF THE COUNTRY
WHERE THE PRODUCT IS INSTALLED. DUEVI DECLINES ANY RESPONSIBILITY IN CASE OF
IMPROPER USE OF THE CUSTOMER OR WRONG INSTALLATION.
DO NOT INSTALL THE DEVICE IN HUMID LOCATIONS OR EXPOSED TO EXTREME
TEMPERATURES. FOR A SOLID AND RELIABLE IMPLANTATION IT IS INDISPENSABLE TO
MAKE SURE THAT THE SURFACE OF THE WALL IS FLAT. FIX THE DEVICE AT AN HEIGHT
THAT ALLOWS AN EASY ACCESS FOR THE USER. INSTALL THE DEVICE IN A LOCATION
COVERED BY A VOLUMETRIC DETECTOR.
DUEVI
DECLINES
ANY
RESPONSIBILITY
IN
CASE
OF
IMPROPER
USE
OF
THE
CUSTOMER.
EVENTUAL
MODIFICATIONS
CARRIED
OUT
FROM
NOT
SPECIALIZED
STAFF
CAN
DAMAGE
THE
DEVICE.
RX2 AP
is a 2 channels self-learning receiving device with 2 independent relay outputs. Each channel may
store up to 5 wireless devices (sensors and remote controls). Each channel is related to a relay output with
voltage-free contacts, that can be used as needed.
The device, enclosed in a plastic case, has an integrated antenna and allows to use wired control panels with
the Duevi series wireless detectors.
1. MEMORY TOTAL RESET
Before using the receiver, it is advisable to make a total reset of the memory, in order to delete any codes that
may be programmed in factory test.
Press and maintain pressed the button
S1
while giving power supply to the device. Continue to press the
button until, after about 5 seconds, you will ear 3 short beeps followed by a long one. Now you can release the
button. The Reset is completed.
2. WIRELESS CODE PROGRAMMING
To enter in this mode, you have to close the jumper
JP2
.
The device will emits 2 beeps and will light on
Ld3
, meaning it is positioned on the channel 1 (RL1);
furthermore if the memory position is empty it will light on also
Ld1
, otherwise if it is occupied will light on
Ld2
.
Now the receiver is positioned on the Code 1.
To select the following Code, press shortly
S1
. You will ear as many beep as the number of the Code (Code2 =
2 beep, Code3 = 3 beep).
After the 5 Codes related to Channel 1, the device pass to the 5 Codes related to Channel 2 (
Ld3
will turn off
and
Ld4
turns on).
If you want to store a detector or a remote control on the selected Code Position, press for few seconds
S1
until
Ld2
will light on (or
Ld1
turns off). Now the receiver is waiting for a wireless code; transmit with the sensor
or the remote control to be programmed.. The receiver confimrs the code memorization with the blinking of
Ld3
.
Repeat this programming operation for any wireless device to be programmed on the receiver, than open the
jumper
JP2
in order to exit from Programming mode.
Code 1
Channel 1
Relay RL1
Code 2
Code 3
Code 4
Code 5
Code 1
Channel 2
Relay RL2
Code 2
Code 3
Code 4
Code 5
