Duevi MOSKITO-AMR, Инструкция по установке и эксплуатации

Страница: 22 / 24

22
LEARNING
AN LEARNING
DIP7 = ON Sensor in TEST mode: ALARM LEDs active J4 = OPENED Anti-opening tamper enabled
DIP6 = ON Buzzer enabled J5 = CLOSED Anti-removal tamper disabled
DIP9 = OFF NEW radio codes J6 = CLOSED Inclinometer tamper disabled
1. Power the detector
2. Wait until the sensor ends its start-up phase.
3. Open the J4 jumper (anti-opening tamper enabled) if is closed.
Close the J5 jumper (anti-removal tamper disabled) if is opened.
Close the J6 jumper (inclinometer tamper disabled) if is opened.
4. On control panel/receiver: enter in radio zone learning (“AN or tamper learning” mode)
5. Without detection, press and hold the tamper switch until the blue LED lights on and the buzzer emits 5 quick “beeps” (if enabled):
 the sensor transmits its AN learning radio code (the blue LED stay on for 2 seconds)

verify that the control panel learned the code (press again the tamper switch if not)
“BY DETECTION” LEARNING (DEVICES WITHOUT AN)
DIP7 = ON Sensor in TEST mode: ALARM LEDs active J4 = CLOSED Anti-opening tamper disabled
DIP6 = ON Buzzer enabled J5 = CLOSED Anti-removal tamper disabled
DIP9 = ON OLD radio codes J6 = CLOSED Inclinometer tamper disabled
1. Power the detector
2. Wait until the sensor ends its start-up phase.
3. Close the J4 jumper (anti-opening tamper enabled) if is opened.
Close the J5 jumper (anti-removal tamper disabled) if is opened.
Close the J6 jumper (inclinometer tamper disabled) if is opened.
4. On control panel/receiver: enter in radio zone learning (“by detection learning” mode)
5. Make the sensor detects violation until the BLUE LED lights on and some “beep” from buzzer (if enabled):

the sensor transmits the alarm radio code

verify that the control panel learned the code (make again an alarm transmission if not)
Note : in this case, the alarm signalling will be generic without specification of which side detected intrusion or difference between tamper
alarm and mask.