Duco DucoBox Silent, Руководство по установке

Страница: 27 / 32

27
ENGLISH
L0001779-L 18.09.2018 Installation manual for DucoBox Silent
06.B Installer / User mode
To add, remove or replace components in the network, the system must be set to ‘Installer mode’� The LED on each component
indicates the active mode of the component (see table in next section)�
‘Installer mode’ can be activated by pressing the DucoBox Silent ‘INST’ button (see drawing in section "04�A Connections & but-
tons" on page 25�) Once the LED on the master unit starts flashing green, it means that ‘Installer mode’ is active� Press ‘INST’
again to return to ‘User mode’ (LED fully on or off)� The system reverts automatically to ‘User mode’ after 15 minutes of inactivity�
06.C LED indications
RED (flashing slowly)
Not in network
RED (flashing rapidly)
Pairing in progress
GREEN (flashing slowly)
In network
GREEN (flashing rapidly)
In network, waiting for associated components
YELLOW (flashing slowly)
Transfer phase (please wait)
YELLOW (on)
Initialising (system configuration in progress)
WHITE or OFF
Normal
BLUE
Component is displayed if changes are being put through via the master
ORANGE
The system is not working correctly because the DucoBox has not been calibrated� Restart the
DucoBox� Follow the guidelines in ‘10 essential tips’ if the problem recurs continually�
06.D Setting type of home
Setting the type of home and number of occupants correctly will provide the ventilation system with a better basis to adjust the
mid-position� There are two types of home: low-rise (e�g� a house) and high-rise (e�g� a flat)� Configuration of this component is
obligatory in the Netherlands. The standard setting for a DucoBox is as a low-rise home for 4 (or more) occupants�
Setting type of home
1
Ensure that ‘Installer Mode’ has been activated (via the ‘INST’ button)�
2
Press ‘LOW’ for a low-rise or ‘HIGH’ for a high-rise home�
3
The yellow LED (see illustration) will flash in a pattern that indicates the
number of occupants: Once, twice (applies for 3 occupants as well) or 4
times (applies for 4 occupants or more)� Press ‘LOW’ or ‘HIGH’ respectively
again until the LED pattern matches the correct number of occupants�
4
Press the ‘INST’ button to exit ‘Installer mode’�
or
HIGH
LOW
INST