Duco 0000-4250, Руководство по установке

Страница: 9 / 16

9
ENGLISH
L2000641 Installation guide for DucoBox Silent (Revision H | 13.07.2020)
RF (wireless communication)
RF components have a maximum free-field range of 350 metres� This distance
will be much less in a building because of obstacles� Therefor you will need
to allow for features such as walls, concrete and metal� All slave components
(except those which are battery powered) also act as repeaters� Signals from
components that are unable to make a (strong) connection with the master
component are forwarded automatically via no more than one other non-bat-
tery-powered component (= hop point)� Please refer to information sheet
RF communication (L8000018) at www�duco�eu for further information�
DUCO RF
Power supply 230 VAC
Wiring 1,5 mm²
Frequency 868 Mhz
Maximum distance
350 m, free field (less
through obstacles)
Maximum number
of components
Up to 25 wireless
components in a
single system
Wired (cabled communication)
Wired components can be daisy-chained (= recommended)� This means that a
separate cable will not be required for each component� A single central power
supply can be used�
The cable required is a 5 x 0�75 mm² data cable� We strongly advise using a shield-
ed cable� This is to prevent any interference that may affect the data communi-
cation� Any Tronic grilles will be supplied with a 5 x 0�25 mm² cable which can be
connected via a splicing terminal block�
DUCO WIRED
Power supply 24 VDC
Wiring
5 x 0�75 mm²
(5 x 0�25 mm² from Tronic
grilles)
Maximum distance up to 300 m
Maximum number
of components
Up to 99 wired
components in a
single system
05 Additional control options
05.A Boxsensors
Boxsensors can be built into a DucoBox Silent Connect and provide
CO
2
and/or humidity measurement in an air duct� A DucoBox Silent
Connect can contain a maximum of one CO
2
and one Humidity
Boxsensor� If the living room (CO
2
measurement) and bathroom
(humidity measurement) are connected to the same duct/zone, the
two Boxsensors can be clipped together�
F connecting Boxsensor
1
Twist the Boxsensor(s) into the desired duct in the box
until the Boxsensor clicks home�
2
Connect the Boxsensors to one of the two connectors
provided on the DucoBox Silent Connect PCB�
Settings
The CO
2
and RH setpoint can be changed using the Duco Network
Control Tool� See www�duco�eu for more information�
RH
CO
2
1
CLICK
CLICK
2
CLICK
RH CO2
DucoBox
A
B
C
D E F G
A
B
C
D E F G