10
MODE SELECTION
The following screens show
MANUAL
,
AUTO
and
OFF
modes. To choose different modes press
MODE/
OK
button.
When the heater is in
AUTO
mode the temperature can be changed by pressing the
+/-
buttons. This
change will remain active until the next programme change or until midnight when the temperature will revert
to the preset value.
When the heater is in
MANUAL
mode use the
+/-
buttons to alter the set temperature.
CHARACTERISTICS
To assist with programming the LCD screen is backlit and will stay illuminated for approximately 10 seconds
after the last button is pressed.
When the heater is operational and the room temperature is lower than the set temperature the heating
symbol will be shown indicating that the heater is producing heat. When the room temperature equals or is
above the set temperature the heating symbol will not be present indicating the heater is not producing heat.
ADJUST PROGRAMMED TEMPERATURES
Adjusting the temperature in the following way will only affect the temperatures used for programmed
modes.
To change these set up temperatures press the
CONFIG
button and the following screen appears:
When the temperature setup icon
starts flashing, press
MODE/OK
button to scroll through each
temperature mode.
Press the
+/-
buttons to change the temperature of each temperature mode then press
OK
button to confirm
and go to the next temperature.
To exit to the temperature setting screen press
CONFIG
button.
