15
Charging a 12 Volt Battery
This generator can be used to charge a 12 volt automotive or storage battery by
taking the following steps:
ONLY
level is low. Never add tap water.
1. Use a wire brush to clean battery terminals if corroded.
2. Before connecting battery to generator, start generator engine. Make sure the
DC Protector is turned to the “ON” position.
3. Securely connect the red cable clamp to the positive (+) battery terminal.
4. Securely connect the black cable clamp to the negative (-) battery terminal.
5. Turn the ESC switch to the “OFF” position to start battery charging.
6.
and 1.28 when measured by a hydrometer.
OPERATION
Note:
It is strongly recommended to check the gravity level of the electrode at least once per hour with a hydrometer to
prevent overcharging and to test the battery’s condition. Be careful to follow the hydrometer manufacture’s instruction.
•
Do not disconnect battery clamps while charging.
Batteries produce explosive gasses.
Disconnecting the battery
clamps while charging could spark and ignite.
•
Do not charge battery in an enclosed area.
•
Never smoke while charging the battery or operating or fueling this generator.
•
Battery electrolyte contains sulfuric acid. Avoid contact with skin, eyes, and clothing. Always wear eye protection
when charging battery.
•
get immediate medical attention. For internal ingestion, drink large quantities of water or milk, followed by milk of
magnesia, beaten egg, or vegetable oil. Contact a medical physician immediately.
WARNING!
Battery electrolyte is poisonous and dangerous.
Содержание D2000iS
Страница 26: ...26 WIRING DIAGRAM W W P 2 1 3 4 ...
Страница 27: ...27 WIRING DIAGRAM P 1 2 3 4 ...