Dualsky FC130, Инструкция по эксплуатации

Страница: 3 / 16

Packing List
Install Instruction
1. FC130 install principal:
- 4 - - 3 -
Radio equipment
You need a 4-channel or higher transmitter. If transmitter only has 4
channels, FC130 will work under Normal Stability by default, cannot
switch mode or switch gyro off during flight. We recommend to use 5
channels or higher transmitter, so CH.5 (usually the GEAR channel)
can be used as switching mode channel.
（
c
）
（
a
）
（
d
）
（
b
）
21021-1
Double
Sided
Tape
（
a
）
FC130 Gyro x 1
（
b
）
Anti-shock double sided tape x 1
（
c
）
3-signal wire (long) x 1
（
d
）
Single-signal wire (long) x 2
● Gyro’s heading direction must be the same as airplane heading
direction
● Gyro should be installed inside of the airplane, close to the
receiver and CG
● Install platform must be level, rugged (recommend to use
plywood), but do not use servo platform
● Must use the double sided tape comes with FC130, do not use
belt, velcro or 3M Dual-Lock
● Do not use foam to cover the gyro
● Gyro cannot be touched by servo horn, linkage or other movable
parts
● Gyro must stay away from motor, engine, ESC and batteries
● Gyro cannot be installed at the outside of airplane, such as wings
or tail
2. FC130 Port Diagram
Port Mapping PIN Location
OUTPUT
INPUT
TOP MIDDLE BOTTOM
Aileron
Elevator
Rudder
Aileron2
VDD
VDD
VDD
VDD
GND
GND
GND
GND
Switch
Aileron
Elevator
SYS
VDD
VDD
Rudder
VDD
GND
GND
Aileron2
GND
* VDD is positive lead. *GND is negative lead.
● Input/output signal wires are close to the top of FC130, middle is
VDD and bottom is GND