14
15
To exit the Descale Mode, press
both
Coffee & Tea Buttons
at the same time and
hold for 5 seconds
. Both lights will go
back to solid illumination. NOTE: if the machine is turned off in
Descale Mode, it will stay in this mode when switched back on.
If you are using water softener, ensure that it is placed back into
the Water Tank once the Water Tank is clean.
EXIT
6
2
DESCALING
REQUIRED
3
FILL TANK
The Coffee & Tea Buttons
will quickly flash, immediately
after switching on, to indicate
descaling is required. Ensure
your descaling product is
suitable for coffee machines
and follow descaling product
instructions carefully.
Ensure the correct ratio of
water is used to create the
Descaling Solution. Turn the
machine off, remove the
Water Tank and fill with the
Descaling Solution. Remove
Drip Tray and place large
container under the nozzle.
KILROCK
DESCALER
MULTI-PURPOSE
KILROCK
DESCALER
MULTI-PURPOSE
KILROCK
DESCALER
MULTI-PURPOSE
KILROCK
DESCALER
MULTI-PURPOSE
KILROCK
DESCALER
MULTI-PURPOSE
1
Ensure your descaling
product is suitable for
coffee machines;
follow
descaling product
instructions carefully.
If you are using a water
softener, ensure water
softener is removed before
adding descaler. Fill water
tank with descale solution.
THE DESCALER
DESCALE
HARD WATER WILL CAUSE LIMESCALE BUILD-UP, RESULTING
IN BLOCKAGES THAT CAUSE PERMANENT DAMAGE.
IMPORTANT NOTICE: PRODUCT FAILURE DUE TO THE
BUILD-UP OF LIMESCALE IS NOT COVERED BY GUARANTEE.
Dualit recommends cleaning and descaling regularly, in a well-ventilated area to prevent
limescale build up in the machine.
Please note: Always clean your machine before
beginning the descaling process. Refer to page 16 for the cleaning section.
See
Limescale warning on page 6 for frequency in your area in accordance with the hardness of your
water. It is essential that a compatible descaler is used - visit www.dualit.com/machine-care for
descaler options. The descale process takes approximately 30 minutes.
Caution: Avoid contact with descaling solution. Steam released during descale
process may be harmful. Risk of scalding and injury.
U
N
PL
U
G W
HEN NO
T
IN
U
SE
SW
ITCH OFF &
5
Ensure the Lever is pushed
down fully and no capsule is
present, then press the Coffee
Button to start descaling. Your
machine will dispense. This will
continue until the Water Tank
is empty. Wait 10 minutes for
the Descaling Solution to take
effect.
4
DISPENSE
RINSE TANK
AND FLUSH
Rinse the Water Tank and
fill with fresh water. Repeat
step 4 (Dispense) and
flush
at least two full tanks
of water through the
machine
to remove any
traces of the Descaling
Solution.
3
PRESS & HOLD
Insert Water Tank. Turn on
and wait for the Coffee & Tea
Buttons to stop flashing. Press
both
Coffee & Tea Buttons
firmly at the same time and
hold for 5 seconds
. Both
Buttons will now quickly flash.
