INSTALLATION
RECESSED MOUNT INSTALLATION (Fig. 3)
1. Turn OFF AC power
2. Separate the wall-mount back plate from sign housing by removing the (2) retaining screws (A)
3. Attach buckles on the backplate using the M3 screws and nuts. Also, attach the (2) guide posts to the
backplate. Remove the 7/8
"
dia. knockout (B) in the bottom and attach the 90° conduit joint to it. Route
the supply leads of the driver board and the sign ground lead through the 90° conduit joint and the
metal conduit.
4. If the message panel is not already attached to the sign, then refer to the ‘Panel addition/Replacement’
section.
5. Re-attach the backplate to the sign housing using the screws (A) previously removed in step 2.
6. Attach the (4) 90° mounting brackets (from their short end) to the backplate using the self-tapping
screws provided. Securely attach the recessed trim panel to the other end of the (4) 90° mounting
brackets using screws provided.
7. Using the template provided, cut a hole in the wall. Slide the recessed mounting plate through the
hole. Extend the side plates as needed using the wing nuts (C). Ensuring that the distance between the
surface of the recessed mounting plate and the wall surface is less than 68mm, securely attach the plate
to the wall studs using screws provided.
8. Attach the metal conduit to a junction box and complete wiring connections inside the box. Refer to the
‘Wiring Diagram’ section.
9. Slide the housing through the hole opening and with the guide posts aligned, snap onto the recessed
mounting plate to complete installation
10. Turn ON AC power and the sign should now light up.
PANEL ADDITION/REPLACEMENT
1. Separate the wall-mount backplate from
sign housing by removing the (2) retaining
screws (B) as shown in Figure 1.
2. Separate the housing top cover assembly
from sign housing by removing the (2)
retaining screws (A) as shown in Figure 1.
3. Slide in the message panel right behind
the blank panel.
4. Re-attach the housing top cover
assembly to the sign housing using the
(2) screws previously removed in step 2.
5. Re-attach the appropriate backplate to
the sign housing using the (2) screws
previously removed in step 1.
Wiring Diagram
120-277V
Orange (Line)
White (Neutral)
RED
Green (Ground)
Driver board
LED
board
B
LK
