INSTALLATION
Note:
This sign may be shipped with the housing and message panel packaged separately. Please refer to the ‘Panel addition/
Replacement’ section for steps to add the message panel to the sign housing.
BACK MOUNT INSTALLATION (Fig 1.)
1. Turn OFF AC power.
2. Separate the backplate from the sign
housing by removing the (2) retaining screws
(B).
3. If the message panel is not already attached
to the sign, then refer to the ‘Panel addition/
Replacment’ section.
4. Remove the appropriate knockouts on
the backplate. Route the supply leads of
the driver board and the sign ground lead
through the 7/8
"
dia. hole in the center of the
backplate.
5. Re-attach the backplate to the sign housing
using the screws (B) previously removed in
step 2.
6. Route the supply and the ground leads
through the hole of the mounting bracket and into the junction box in the wall.
7. Complete wiring connections inside the junction box. Refer to the ‘Wiring Diagram” section.
8. Securely attach the mounting bracket to the junction box using the screws provided.
9. Securely mount the housing using the (2) square holes on the backplate and the hooks on the mounting
bracket. Lock from the bottom using the self-tapping screw (C) to finish installation.
10. Turn ON AC power and the sign should now be lit up.
Figure 1
CEILING/END MOUNT INSTALLATION (Fig. 2)
1. Turn OFF AC power
2. Separate the wall-mount backplate from housing by
removing the (2) retaining screws (B).
3. If the message panel is not already attached to the sign,
then refer to the ‘Panel addition/Replacement’ section.
4. Remove the appropriate knockouts on the housing top (for
ceiling-mount install) or side (for end-mount install) cover
assembly. Attach the mounting canopy to the assembly
using the screws provided. Route the supply leads of the
driver board and the sign ground lead through the hole in
the center of the assembly and the canopy.
5. Attach the ceiling-mount backplate to sign housing using
the (2) retaining screws (B).
6. Route the supply and the ground leads through the hold of
the mounting bracket and into the junction box in the wall
or ceiling.
7. Complete wiring connections inside the junction box.
Refer to the ‘Wiring Diagram’ section.
8. Securely attach the mounting plate to the junction box
using the screws provided. Securely attach the canopy
to the plate using the screws provided to finish the
installation.
9. Turn ON AC power and the sign should now light up.
Figure 2
