10
V4.5E
STEP 6
Connect Tubing (continued)
AIR GAP FROM FAUCET TO RO ASSEMBLY
1
Locate Membrane Drain port at bottom of Membrane.
2
Take Elbow Fitting and press down into Membrane Drain port to connect the fitting.
3
Locate the 1/4” Red Tubing attached to the Air Gap barb on the Auxiliary Faucet Body.
4
Measure the length of 1/4” Red Tubing necessary to connect to the Membrane Drain
port. The tubing must be straight as possible with no loops, dips, low spots or kinks.
5
Cut the 1/4” Red Tubing squarely to correct length with a utility knife.
6
Insert the restrictor into the end of the red tubing.
7
Insert the Red Tubing into the open end of the Elbow Fitting.
8
Gently tug on the Red Tubing to ensure it is firmly connected to the Elbow Fitting.
CONNECT 3/8” RED TUBE FROM REVERSE OSMOSIS FAUCET TO DRAIN ADAPTER
1
Locate 3/8” Red Plastic Tubing already attached to RO Faucet Body.
2
The other end needs to be attached to collet on sink Drain Connector.
3
Cut 3/8” Red Plastic Tubing as needed to route in as straight of a run as possible,
without loops, dips, low spots, or kinks.
4
Cut end of 3/8” Red Plastic Tubing square with a sharp utility knife.
5
Insert all the way into fitting approximately 1” until it stops.
6
Pull on tube to be sure it is held firmly in fitting.
NOTE: Drain line into drain must be level.
CONNECT TUBING FROM RO SYSTEM HEAD TO WATER STORAGE TANK
1
Use remaining 3/8” White Tubing and determine length necessary to connect Tank
outlet (labeled “TANK”) on RO System Head to Water Storage Tank.
2
Cut 3/8” White Plastic Tubing square with a sharp utility knife.
3
Loosen the compression nut on the top of the tank - DO NOT REMOVE.
4
Wet end of tubing and insert into compression nut of Tank Connector fitting (which was
connected to tank previously).
5
Tighten compression nut to secure tubing to Tank Connector.
6
Insert other end of 3/8” White Plastic Tubing into outlet of RO System Head (labeled
“TANK”) approximately 5/8” until it stops.
**NOTE: SYSTEM WILL NOT OPERATE WITHOUT RESTRICTOR**
NOTE: Tubing lengths should allow for the removal of the assembly from the mounting
screws for servicing. If tubing lengths are shortened for neater appearance, it may be
necessary to keep the assembly on the mounting screws for service.
NOTE: Codes in the state of Massachusetts require installation by a licensed plumber
and do not permit the use of saddle valves. If you live in the state of Massachusetts,
review plumbing code 248-CMR of the Commonwealth of Massachusetts before
proceeding with the installation.
6
*RESTRICTOR
Drain
Port
1/4"
water
line
Elbow
Fitting
FAUCET
TANK
FAUCET
TANK
Loosen Compression Nut
