2- IMPORTANT SAFETY INFORMATION
2.1 Fire prevention:
2.2 Prevention of electric shock:
2.3 Protection against ultraviolet radiation:
2.4 Safety:
2.5 Level of protection against the penetration of solid and liquid matter
1. XR250WASH uses a Philips MSD250/2 lamp . The use of any alternative lamp is not
recommended and will null and void the fixture's warranty.
2. Never locate the fixture on any flammable surface.
3. Minimum distance from flammable materials: 0.5 m.
4. Minimum distance from the closest illuminable surface: 2 m.
5. Replace any blown or damaged fuses only with those of identical value. Refer to the
wiring diagram if there is any doubt.
6. Connect the projector to mains power via a thermal magnetic circuit breaker.
- High voltage is present inside the unit. Isolate the projector from the mains supply
prior to performing any function which involves touching the inside of the unit, including
lamp replacement.
- The level of technology inherent in the XR250WASH requires the assistance of
specialised personnel for all servicing. Refer all work to your authorised DTS service
centre.
- A good earth connection is essential for proper functioning of the projector.
Never connect the unit without proper earth connection.
- The fixture should never be located in a position exposed to rain or in areas of extreme
humidity. A steady supply of circulating air is essential.
1. Never turn the lamp on if any of the lenses, filters or the carbon fibre housing is
damaged. Their respective shielding functions will only operate efficiently if they are in
perfect working order.
2. Never look directly into the lamp when it is on.
- The projector should always be installed with bolts, clamps and other fixtures that are
capable of supporting the weight of the unit.
- Always use a second safety chain of a suitable rating to sustain the weight of the unit
in case of the failure of the main fixing point.
- The external surface of the unit, at various points, may exceed 150°C. Never handle the
unit until at least 10 minutes have elapsed since the lamp was turned off.
- Always replace the lamp if any physical damage is evident.
- Never install the fixture in an enclosed area lacking sufficient air flow. The ambient
temperature should not exceed 35°C.
- A hot lamp may explode, so always wait for at least 10 minutes to elapse after the unit
has been turned off prior to attempting to replace the lamp.
Always wear suitable hand protection when handling the lamp.
- The projector is classified as an ordinary appliance and its level of protection against
the penetration of solid and liquid matter is IP 20. XR250WASH uses MSD250/2 Philips
lamps with GY 9.5 base.
The temperature inside the projector can reach 150° C after just 5 minutes, but it can
2
XR250
W A S H